PROBLEMS IN THE DESIGN OR STRUCTURE OF AN AIRCRAFT IN JACKSON, MS 

After any kind of aviation accident, it’s critically essential to determine exactly what went wrong and how a similar accident can be prevented in the future. When aviation accidents are attributed to factors like design flaws or structural failures, aircraft manufacturers need to be held accountable. Planes and jets have to perform under extremely rough circumstances. From high speeds and high altitudes to extreme weather and daily flights, an aircraft has to be up to the task. Aerodynamics, mechanical equipment, engines, landing gears and every piece of the aircraft down to the smallest screw must be able to withstand the rigors of flight.

Aircraft Design Flaws 

Thankfully, there are standards in place to help make sure aircraft are up to flight safety standards before they hit the market. However, that doesn’t mean that design flaws and structural failures are nonexistent. They can and do happen, and when they do, it’s important to get to the bottom of exactly what failed. Ideally, any potential design defects or structural flaws would have been discovered during initial testing of the materials and design. If something slips through the cracks, for whatever reason, lives can be put at risk. From design to manufacturing, each detail of an aircraft has to be fully evaluated, calculated and built to precise and high standards.

Structural Failure of Aircraft

When there are structural failures on an aircraft, they’re likely to happen inflight, when the conditions are most dangerous and extreme. Unfortunately, that means that a midair structural failure could lead to an injury-causing or fatal crash. The materials used to make planes and jets have to be extremely strong, due to the harsh conditions at high altitude. There are ways to test materials prior to manufacturing, but if the manufacturer doesn’t follow through on all design and testing protocols, weak or unsafe materials can make their way to the assembly line.

Aircraft Testing

One of the most important parts of aircraft manufacturing is the testing phase. Each design, material and structure needs to be thoroughly tested for strength and safety prior to mass manufacturing. Planes don’t fall apart on the ground. If something is going to go wrong, it’s going to happen in the air, where pilots and passengers are putting their lives on the line. There are very established procedures and protocols for aircraft materials testing. As long as manufacturers are following all appropriate procedures, they should be able to determine what designs and materials are safe for flight, before manufacturing.